Komatsu — REMOVAL

DISASSEMBLY AND ASSEMBLY REVOLVING FRAME 12 REVOLVING FRAME REMOVAL 1. Remove work equipment. For details, see WORK EQUIPMENT. WARNING! When disconnecting the hydraulic hoses, release the remaining pressure in the hydraulic circuit. For details, see TESTING AND ADJUSTING. 2. Disconnect boom cylinder hoses (1). # Fit blind plugs in the hoses and make it possible to swing the upper structure. 3. Raise boom cylinder (2), then pull out foot pin (3) and lift off. Remove the remaining cylinder in the same way. Boom cylinder........................................................... 410 kg 4. Remove counterweight. For details, see COUNTERWEIGHT. 5. Remove engine hood (4), cover (5), and frame (6).

# For details of the method of removing the engine hood, see HYDRAULIC COOLER. 6. Leave three mounting bolts each at front and rear of revolving frame, and remove other mounting bolts. # Swing the upper structure and set to a position where it is easy to remove the mounting bolts. 7. Disconnect drain hoses (7) and (8). # Install blind plugs in the drain hoses. 8. Disconnect travel hoses (9) and (10), and speed selector hose (11). 9. Pull out pin (12), and disconnect plate (13) from swivel joint. PC300LL-6 30-21