hyundai R60WVS Pro — 6. STEERING VALVE

Disassembly Cleanliness is extremely important when repairing a steering cont rol unit. Work in a clean area. Before disc onnecting lines, clean port area of unit thorough ly. Use a wire brushto remove foreign material and debris from around external joints of the unit. Note Although not all drawings show the unit in a vice, we recommend that you keep the unit in vice during disassembly. Follow the clamping procedures explained throughout the manual. Meter (Gerotor) End 1. Clamp unit in vice, Gerotor end up. Clamp lightly on edges of port face sides (see figure). Use protective material on vice jaws. Housing Figure 1 distortion can result if jaws are over- tightened. 2.

Remove M10 cap screws. 3. Remove end cap. Cap Screw End Cap 4. Remove drive Spacer(If included) 5. Remove seal from Gerotor. Spacer Seal Figure 2 7-90