Disassembly 12. Carefully remove anti-cavitation check valves and manual steering check Manual Steering Valve valve(roll pin and ball ) from bolts holes, by tipping. Note:Do not remove any valves other than manual steering check valve and anti- Cylinder Relief Valves Figure 5 cavitation check valves . All other valves are factory preset and are non- serviceable 13. Carefully remove the spool-sleeve assembly from hous ing in upright position Note: Do not cock spool- sleeve assembly in housing Rotate spool- sleeve assembly slowly when removing it from housing 14. Push pin from spool-sleeve assembly. Figure 6 Needle Thrust Bearing Bearing Race 15.
Remove the bearing race, needle thrust bearing and bearing race, step by step Shaft Seals from the housing. 16. Remove Shaft seals from seal gland bushing. Figure 7 7-92