hyundai R60WVS Pro — 7. AXLE

2. 2. GENERAL INTRODUCTIONS GENERAL INTRODUCTIONS 1) 1) Introduction Introduction The efficiency and continued operation of mechanical units depends on constant and correct maintenance and also on efficient repair work should there be a break-down or malfunction. The instructions in this manual have been made based on a complete overhaul of the unit. However the mechanic must decide whether or not it is necessary to dismantle the individual components when only partial repair work is needed. The manual provided a quick and sure guide which, with the use of photographs and diagrams illustrating the various phases of the operations, allows accurate work to take place.

Therefore all the information needed for correct disassembly, the relative checks and assembly of each individual component, has been written down. In order to remove the differential unit from the vehicle, the manuals provided by the vehicle manufacturer should be consulted. In describing the following operations it is presumed that the unit has already been removed from the vehicle. Throughout the phases of repair or maintenance work it is advisable to use proper equipment such as : trestles, or supporting benches, plastic or copper hammers, appropriate levers, extractors and specific spanners or wrenches.

So that the work is facilitated and the working surfaces and the operators themselves are protected. Before going on to disassemble the parts it is best to thoroughly clean the unit, removing any encrusted or accumulated greases and then drain the oil through the oil-draining plugs. 2) I ntroductory statement ntroductory statement All the disassembled mechanical units should be thoroughly cleaned with appropriate products and then restored or replaced if damage, wear, cracking or seizing have occurred.

In particular, thoroughly check the state of all moving parts (bearing, gears, crown wheel and pinion, shafts) and sealing parts (O-ring, oil shield) which are subject to major stress and wear. In any case it is advisable to replace the seals every time a component is overhauled or repaired. During assembly the sealing rings must be lubricated on the sealing edge. In the case of the crown wheel and pinion, replacement of one requires the replacement of the other. During assembly the prescribed pre-loading and backlash of the parts must be maintained.

3) Maintenance and repair Maintenance and repair We have compiled these instructions for maintenance and repair in order to facilitate any such work on the CLARK-HURTH Components differential units and gear change unit. 7-100