⑮ Tighten the new fitting screws (13) of top articulation pins in sequence using the cross tightening method. · Torque wrench setting : 13.1~14.5 kgf · m (94.8~105 lbf · ft ) 16 Tighten the new fitting screws (19) of bottom articulation pins in sequence using the cross tightening method. · Torque wrench setting : 13.1~14.5 kgf · m (94.8~105 lbf · ft ) Check by means of a lever that there is no vertical gap. In case there is any gap, determine the width and reduce it by removing shims. 17 18 Check the torque of the pins, which has to be between 4.08 and 8.16 kgf · m . If the preliminary measured value is too high, the shims have to be increased. 7-116