hyundai R60WVS Pro — 10. BOOM, ARM AND BUCKET CYLINDER

GROUP 10 BOOM, ARM AND BUCKET CYLINDERS 1. REMOVAL AND INSTALL 1. REMOVAL AND INSTALL 1) 1) BUCKET CYLINDER BUCKET CYLINDER (1) (1) Removal Removal Expand the arm and bucket fully, lower the work equipment to the ground and stop the engine. Operate the control levers and pedals several times to release the remaining pressure in the hydraulic piping. Loosen the breather slowly to release Loosen the breather slowly to release the pressure inside the hydraulic tank. the pressure inside the hydraulic tank. Escaping fluid under pressure can Escaping fluid under pressure can penetrate the skin causing serious penetrate the skin causing serious injury. injury.

Fit blind plugs in the hoses after disconn- ecting them, to prevent dirt or dust from entering. Bucket Cylinder Arm Set block between bucket cylinder and arm. ① Wooden block ② Remove bolt (2), nut (3) and pull out pin (1). Tie the rod with wire to prevent it from coming out. ③ Disconnect bucket cylinder hoses (4) and put plugs (5) on cylinder pipe. 4 5 4 7-257 1 2 3 R5577CY03 R 5577CY03