4) 4) ASSEMBLY ASSEMBLY (1) (1) Assemble cylinder head assembly Assemble cylinder head assembly Check for scratches or rough surfaces if found smooth with an oil stone. Coat the inner face of rod cover (5) with hydraulic oil. ① ② Coat dust wiper (10) with grease and fit dust wiper (10) to the bottom of the hole of dust seal. At this time, press a pad metal to the metal ring of dust seal. Fit snap ring (11) to the stop face. Press here (Straight down) Metal 10 ③ ④ Fit U-packing (9) and buffer seal (8) to corresponding grooves, in that order. Coat each packing with hydraulic oil before fitting it. Insert the backup ring until one side of it is inserted into groove.
Right Wrong U-packing (9) has its own fitting direction. Therefore, confirm it before fitting them. Fitting U-packing (9) upside down may damage its lip. Therefore check the correct direction that is shown in fig. Push bar 9 7-272