24. SERVICE PROCEDURE 24.2.12 ADJUSTING PARKING BRAKE The parking brake is a sealed wet type disc brake, so the brake itself does not need adjusting. However, if the travel of the brake pedal increases because of looseness of the control cable mount or elongation of the control cable, adjust as follows. Checking Depress the parking brake pedal with a force of approx. 294 N (30 kgf). If the travel of brake pedal is more than 13 clicks, check for looseness of the control cable mount (pedal end and brake end). If any looseness is found, tighten and then adjust as follows. Adjusting WARNING When adjusting, always block 1 the tires and prevent the machine from slipping.
Secure the front and rear frames with safety bar 2 and pin 3 . 1. Pull release lever 4 and release the parking brake. 2. Loosen locknut 5 and remove clevis pin 7 . 3. Pull lever 8 at the parking brake end fully to release the brake, and set it in the release position. 4. Screw in clevis 6 , align the pin with the pin hole in lever 8 at the parking brake end, then assemble clevis pin 7 and tighten locknut 5 . 5. After adjusting, depress parking brake pedal 9 with a force of approx. 294 N (30 kgf), and check that the travel of the pedal is 7 – 11 clicks. 3-36