REMOVAL AND INSTALLATION BUCKET CYLINDER INSTALLATION OF THE BUCKET CYLINDER To install, reverse removal procedure. 1 When aligning the positions between the hole and the pin, do not insert fingers into the holes to check alignment. Inside the bushings: Litio EP MS2 NLGI 2 Pin screws: 49 Nm 2 # Insert the removed shims and, if necessary, add more until the residual clearance is about 1 mm. MAX 1mm 3 RKS01780 # Insert the removed shims and, if necessary, add more until the residual clearance is about 1 mm. 1 - Start the engine and bleed the air from the cylinder. (For details, see «20. TESTING AND ADJUSTMENTS»).
# After bleeding the air, check the level of oil in the tank RKS01790 30-43 SK714-5 SK815-5