Komatsu — WORK EQUIPMENT CYLINDERS

REMOVAL AND INSTALLATION WORK EQUIPMENT CYLINDERS 5 - Mount the piston rod group (4) onto the tool A and raise the mobile part up to the end of its stroke. 6 - Put the cylinder (2) into a vertical position and guide the piston into the tool M . 7 - Lower the apparatus supporting the piston rod (4) in or- der to insert the piston into the cylinder liner (2). 4 A 8 - Remove the tool M from the cylinder and then lower the apparatus A even further, until the head (3) and the pi- ston rod approach the cylinder. M 9 - Placethe cylinder(2)in positionforscrewingin the head (3). 10 - Insert the head into the cylinder and screw it in by hand for a few turns.

2 RKSA1091 11 - Attach the special wrench C to the dynamometric tool D and screw the head (3) fully home. C D Head: • Raising cylinder: 412 41 Nm • Bucket cylinder: 441 44 Nm 3 2 12 - Mount the guard rings (1) on both sides of the cylinder and the piston rod. RKSA1071 30-49 SK714-5 SK815-5