3.1.37. Oil seal Take off the rear oil seal using an oil seal disassembling jig. If only the inside guide ring is removed, use a special tool to take off the outside seal. 3.1.38. Flywheel housing Loosen the housing fixing bolts disas- semble the flywheel housing. EAMD043I 3.1.39. Cam shaft and tappet Remove the cam shaft gear. Take off the cam shaft gear thrust washer. Take out the cam shaft using care not to damage the cam shaft. Slide out the tappets by hand. EAMD044I 3.1.40. Crankshaft gear and oil pump idle gear Loosen the socket head bolts and take out the oil pump idle gear. Use a puller to remove the crankshaft gear. - 39 -