daewoo DE12T / P126TI — Daewoo DE12T / P126TI User Manual

(A) Specification Note : * Droop is based on a speed sensor frequency of 4,000 Hz and an actuator current change of 1 amp from no load to full load. Applications with higher speed sensor signals will experience less percentage of droop. Applications with more actuator current change will experience higher percentages of droop. See droop description for specific details on operation of droop ranges. ** Protected against reverse voltage by a series diode. A 15 Amp. fuse must be Installed in the positive battery lead, *** Protected against short circuit to actuator (shuts off current to actuator), unit automati- cally turns back on when shorts is removed.

- 96 - PERFORMANCE Isochronous Operation/steady State Stability Speed Range/Governor Speed Drift with Temperature Idle Adjust CW Idle Adjust CCW Droop Range Droop Adj. Max. (K-L Jumpered) Droop Adj. Min. (K-L Jumpered) Speed Trim Range Remote Variable Speed Range Terminal Sensitivity J L N P Speed switch adjustment range ±0.25% or better ±1 K ~ 7.5 KHz continuous ±1% Maximum 60% of set speed Less than 1,200 Hz. 1 ~ 5 % regulation* 400 Hz ± 75 Hz per 1.0 A change 15 Hz ± 6 Hz. per 1.0 A change ± 200 HZ 500 ~ 7.5 Hz or any part thereof 100 Hz ± 15 Hz/Volt @ 5.0 K Impedance 735 Hz ± 60 Hz/Volt @ 65 K Impedance 148 Hz ± 10 Hz/Vo1t @ 1 Meg. Impedance 10 VDC Supply @ 20 ma Max.

1,000 ~ 10,000 Hz ENVIRONMENTAL Ambient Operating Temperature Range Relative Humidity All Surface Finishes - 40 ˚F to 180˚F (- 40 ˚C to + 85 ˚C) up to 95 % Fungus Proof and Corrosion Resistant INPUT POWER Supply Polarity Power Consumption Actuator Current Range @ 77 ˚F (25 ˚C) -(Inductive Load) Speed Sensor Signal Speed switch relay contacts (N.O. and N.C.) 12 or 24 VDC Battery Systems (Transient and Reverse Voltage Protected)** Negative Ground (Case Isolated) 50 ma continuous plus actuator current Min.2.5 Amps/ Max.

10 Amps continuous *** 0.5 ~ 120 Volts RMS 10 Amps RELIABILITY Vibration Testing 1G @ 20 ~ 100 Hz 100% Functionally Tested PHYSICAL Dimensions Weight Mounting See Outline 1.8 lbs (820 grams) Any Position, Vertical Preferred