(2) Reassembly After removing carbon deposit, sub- merge the nozzle in diesel oil and clean it. Replace all the gaskets with new ones. Assemble the parts and tighten them to specified torque. (3) Adjustment Remove the cap nut and assemble a nozzle to a nozzle tester. With the adjusting screw loosened, it. Operate the nozzle tester lever at the operate the nozzle 2 ~ 3 times to bleed specified rate. Adjust the injection pressure to the stan- screw. After adjusting the injection pressure, dard pressure using the adjusting tighten the cap nut to specified torque. Re-check the injection pressure and see if the spray pattern is normal.
(4) Testing With the nozzle assembled to a nozzle tester and pressure of 20 ~ 21 MPa (200 ~ 210 bar) applied, check the nozzle for fuel leakage. EAMC022I - 106 - EA0M3003