- 136 - Remarks allowable 1st : 160, 2nd : 220 Retighten head bolt after running in at 200rpm or more (20˚C) Correction Correct or replace Submerge in water and replace if air bubbles found Replace if contacted impeller and pump body Temperature above this not Replace if defective Stroke : minimum 8mm Correct or replace Clean or replace Adjust by shim Replace valve Replace cyl. head and nozzle Refer to supplement “running-in” Overhaul the engine Correct Limit for use - - - - - - 95 103 - - - - - - - - - 24 or more - Standard value for assembly - 1.0 0.5 0.2 Approx.
270 0.3~0.6 90~95 103 83 95 or lower - - 220 1.6 4.3 0.2~0.4 - 24~28 10% or less ± against average Check Radiator & water pump for corrosion, damage & improper connecting Test for leakage(air pressure) kg/cm2 Pressure valve for opening pressure kg/cm2 Negative pressure valve for opening pressure (kg/cm2) Engine speed 1,800rpm Delivery volume l/min Water temp 24˚C Back pressure:1kg/cm2 Clearance between pump impeller & pump body Operating temperature(permissible temp.) ˚C Permissible temperature in a short time ˚C Thermostat opening temp. (under atmospheric pressure) ˚C Full opening temp.
˚C Fuel pipe, injection pipe & Nozzle holder for damage, cracks, looseness, bad packing Fuel filter element for damage Injection pressure of injection nozzle (kg/cm2) Opening pressure of overflow valve (kg/cm2) Height of projected nozzle on the cyl. head (mm) Clearance between injection pump coupling and coupling (mm) Running-in the engine Cylinder compression Pressure of cylinder(kg/cm2) Compression pressure difference of each cylinder Part Radiator Water pump Cooling water temp Thermostat Piping and the other Cylinder pressure Group Cooling system Fuel System Inspection at completion