5.5. Fuel system 5.5.1. Fuel filter After every 1,200 hour of operation, drain water separator. Shut off the engine. Use your hand to the water and sediment from the fuel- 1 3 open the drain valve . Turn the valve counter clockwise 6 4 5 2 approximately 2 ~ 3 turns until draining occurs. Drain the filter sump of water until close fuel is visible. Turn the valve clockwise to close the drain 6 EA2O4009 valve. Do not over tighten the valve, overtightening can damage the threads. 5.5.2. Replacement of fuel filter Clean the area around the fuel filter head . Remove the fuel filter by turning it 3 counter-clockwise with filter wrench.
2 (Discard the used filter.) Remove the fuel filter thread adapter seal ring . Use a clean lint free cloth to clean the 4 gasket surface of the fuel filter head . Install the new thread adapter seal ring 3 EA7O5008 supplied with the new filter. Use clean oil to lubricate the filter seal , and fill the new filter with clean fuel. Install the filter on the filter head . Tighten the filter until the gasket contacts the filter head surface. Tighten the filter on additional one-half to three-fourths of a turn with the filter wrench, on as 4 5 3 specified by the filter manufacturer. Notice : Mechanical over tightening of the filter can distort the thread or damage the filter element seal. - 37 -