. OPERATION DETAILED CONTROLS AND GAUGES Display Monitor Monitor (7) displays the status of temperature setting (a), air flow (b), and vents (c). When OFF switch (1) is pressed, the display of temperature setting (a) and air flow (b) goes out, and operation stops. 3 - 50 Auto Switch With switch (5), the air flow, vents, and air source Wi ents ource (RECIRC/FRESH) ar e automatically selecte d according to th e set temperature. When auto switch ( lights up. 5) is pressed, the lamp above the auto switch Press switch (5), t the temperature, a control.
When the control hen use temperature control switch (3) to set nd run the air conditioner under automatic is switched from automatic operation to manual operation, it is possible to operate t he to change air flow, vents, and air sour ce (RECIRC/FRESH). When manual c ontrol is used, lamp abov e the auto switch g oes out. REMARK When Auto Mode is selected, if the set t emperatu re is set to 18.0 °C (64.4 ° F) or 32.0 °C (89.6 °F), the air fl ow is always set to High, b ut this is not a problem. FRESH/RECIRC Selec tor Switch Switch (6) is used to switch the air sourc e between recirculat ion of the air inside the cab and intake of fresh air f rom t he outside .
When RECIRC but ton (A) or FRESH b utto n (B) i s pressed, lamp (C) above the swit flow. ch lights up to indicate the source of the air ource During automatic o and outside air (FR peration, the selection of inside air ESH) is performed automatically. (RECIRC) Outsid RECIRC Use thi e air is shut off and only air inside the cab is circulated. s setting to perform rapid cooling of the cab or when outside air is dir Outsid FRESH Use thi e air is taten into the cab. s setting to take in fresh air when performing demisting.