. OPERATION MACHINE OPERATIONS AND CONTROLS working lamp lights up. Check Electric Wiring CAUTION 3 - 87 Check Working Lam p Switch Check that the wor king lamps and lamps inside th e instruments li ght up properly. Che ck also that there is no dirt or damage. any lamp does n If distributor to carry o 1. Turn the startin g switch to the ON po 2. Set the lamp s If fuses are freque ntly blown or if there ar e traces o f short-circuiting on the electrical wiring, promptly ask your Komatsu omatsu distributor to locat e the cause and make th e repair. Keep the top surfac e of the battery clean a nd check t he breath er hole i n the battery cap.
If it is clogged with dirt or dus t, wash the battery cap to c lear the breather hole. Check that there i s no damage to the fuses; th at fuses of the specified capacity are used; that there is no disconnection or tra ce of short-circuiting i n the elec tric wirin g and n o damage to the cov ering. Check also tha t there is no loosened term inals. If any, tighten t hem. Moreover, pay part alternator. Be sure to check th immediately. Check Function of H orn g switch to the ON position. n switch and check that the horn sounds 1. Turn the startin 2. Press the hor immediately.
Note that if the air tank is at the that the water d engine and wait again to check i If the horn still d distributor for re 1. Turn the startin g switch to the ON po 2. Press the hor air tank is empty or th e water d rain valv e in the OPEN position, the h orn will n ot sound . Check rain Valve is at the C LOSE p osition, s tart the for 1 or 2 minutes, th en press the horn switch f it sounds. oes not sound, please contact your Komatsu pairs. t your K omatsu