Komatsu — BUCKET REPLACEMENT

. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS NOTICE them. 3 - 134 2. Re move the stopp er at the end of the pin, then pull o ut pins (A) d (B) and remo After re movin g the pins, make sure that mu d or sand does not g et on them. Dust se als are fitted at bo th ends of the bus hings, be careful not to damage 3. Ali gn the arm (3) w ith holes (1) of the replacement b ucket and link ( 4) with h oles (2) , then in sert grease-coate d (B) i nto hole ( 1) and hole (2) REMAR Car ry out installatio n in the revers e order to removal.

Wh en installing bu cket (6), it is ea sy to damage the O-ring (7), so f it O-ring (7) to b ucket (6) in the p osition shown in d iagram on the right. After inse rting pin, fit the O -ring correctly in th e groove. Inst pin. Add If th e dus t seal is d amaged when r eplacing the bucke t, replace it wi th a n ew one. I f the defective d ust seal is not rep laced, dirt and sand enter the pin portion and cause abnormal w ear to the pin.