. OPERATION LONG TERM STORAGE LONG TERM STORAGE BEFORE STORAGE NOTICE To protect the hydraulic cylinder piston rod while in storage, keep the work equipment in the posture shown at right. (This prevents rust from developing on the piston rod) DURING STORAGE WARNING AFTER STORAGE 3 - 153 When putting the machine in storage fo r a long time (more than one month), do as follows. Clean and wash all parts, then store t he machine indoors. If the machine has to be stored o utdoors, s elect level ground and cover the machine with c anvas. vents moisture from collecting. torage. aulic cylinder piston rod with grease. Completely fill the fuel tank.
This pre Lubricate and change the oil before s Coat the exposed portion of the hydr Disconnect the negative terminals of t he battery and cover it or remove it from the machine an d store it separately. Lock each control lever and pedal wit h the lock lever and pedal lock. To prevent rust, fill with Komatsu gen uine supercoolant (AF-NAC) to give a density of at leas t 30% for the engine coolant. If it is necessary to perform the rust-preventi on operation while the machine is indoors, open the doors an d window s to improve ventilation and prevent gas poisoning. During storage, operate and move the machine for a short distance once a month so that a n ew film of oil will coat moving parts.
At the same time, also charge the battery. wipe off all the grease from the hydraulic cylinder rods. When operating the work equipment, wipe off all the grease from the hydraulic cylinder rod If the machine is equipped with an air conditioner, operate the air conditioner for 3 to 5 minu tes once a mon th to lubricateall parts of the air conditioner check the refrigerant level twice a ye compressor. Always run the engine at low idle when do ing this. In addition, ar. NOTICE If the machine has been stored without carr ying out the monthly rust-prevention operation, consult you r Komatsu distributor before using it. When using the machine after long-term storage, do as follows before using it.
c cylinder rods. oints. Wipe off the grease from the hydrauli Add oil and grease at all lubrication p When the machine is stored for a long period, moisture in the air will mix with the oil. Check th e oil befor e and after starting the engine. If there is water i n the oil, change all the oil.