. OPERATION TROUBLES AND ACTIONS Connecting and Disconnecting Booster Cables WARNING When connecting the cables, never contact the positive (+) and negative (-) terminals. When starting the engine with a booster cable, always wear safety be as the the 3 - 159 Starting Engine with Booste When starting the engine with a booster cable, do as follows. glasses. Be careful not to let the normal m each other. This prevents sparks f could ignite the hydrogen gas gi achine and problem machine con rom generating near the battery w ven off by the battery. If hydrogen explodes, it could cause serious injury.
Be c areful not to make a mistake when connecting a booster cabl the l er structure frame), a spark wil spot as far away from the batter possible. (Avoid the work equipm ent, however, because it is not a g conductor) When removing the booster ca ble, exercise good care so that Whe booster cable clips may not co chassis. ntact each other, or they contact NOTICE starting system for this machine uses 24V. For the normal machine, also use a 24V battery. size of the booster cable and clip should be suitable for the battry size. The starting system for this mac hine uses 24V. For the normal ma chine, also use a The size of the booster cable and clip should be suitable for the ba ttry size.
The battery of the normal machin e must be the same capacity as t hat of the engine to be started. Chec k the cables and clips for da mage or corrosion. ps are firmly connected. rking brake levers of both machine are in the LOCK position. EUTRAL position. Make sure that the cables and cli Chec k that the lock levers and pa rking brake levers of both machi ne are in th Chec k that each lever is in the N