. MAINTENANCE MAINTENANCE PROCEDURE How to Remove Slinging Loop WARNING In case a slinging loop is fitted to the bucket tooth, remove it. If digging work is started without the slinging loop being removed, there is the danger that the slinging loop is broken and broken pieces are sent 1. Put block (3) under the bottom of the bucket and stop the engine. 4 - 30 flying a It is quit while th Hold the and put round. e dangerous if the work equipment begins to move by mistake e slinging loop is being removed. work equipment in a steady and safe posture; stop the engine; the lock lever in the "LOCK" position.
he slinging loop is being removed, there is the danger that While t he slinging loop is be broken slinging loop pieces ar e sent flying around, so wea r protective tools su ch as safety glasses. Never h it the tooth against a b oulder for the purpose of re moving the slinging loop. s the danger that the broken slinging loop will be sent flying in pieces, causing a personal injury.
There i around in pieces, causing a pe NOTICE If the mach ine is operated without the sling being removed, th e following problems may possibly ari When th e work equipment is p ulled back, the slinging loop at the tip of the tooth interferes with th A crack occurring at the time o f sling breakage progresses to the tooth , resulting in the breakage The slin g is broken in the diggi ng operation, broken pieces are mixed i n the sand and earth to be Be sure to remove the slinging lo op in the following steps. 2. Withi n 15 seconds after stopping the engine, m ove each contr in all ol lever (for work equ ipment and travel) to the full stroke directions to release the internal pressure. 3.
Chec k that the work equip ment is in a stable conditio n, then set the lo ck lever to the LOCK position (L).