. MAINTENANCE MAINTENANCE PROCEDURE ADJUST BUCKET CLEARANCE WARNING (7): Bucket (8): Arm (9): Bush 4 - 32 It is dangerous if the work eq uipment is mistakenly moved when adjusting the bucket clearance. Set t he work equipment in a s table condition, stop the e ngine, the n set lock leve r (1) securely to the LOC If there is excessive free p lay on the coupling section of th e bucket and arm, adjust the buck et clearance in the following ma nner. 1. 2. 3. 4. 1. Set the work equipm ent to the position show n in the diagram on the right, then stop the engine and set th e lock le ver (1) to the LOCK position (L) . bolts (4), plate (2) and plate (6). uivalent in size to free play (a).
is 0.5 mm or 1.0 mm (0.02 or 0.04 in). 2. 3. Loosen 3 bolts (3), 6 Take out shims (5) eq bolts (4), plate (2) and uivalent in size to free plate (6). play (a). Thickness of shim (5) is 0.5 mm or 1.0 mm ( 0.02 or 0 When free play (a) is less than a thickness compress the shims b 4. Tighten 3 bolts (3) an Wit h this adjustment, clea rance (b) becomes larger, but play (a) is