Komatsu — BLEEDING AIR FROM FUEL CIRCUIT

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4. Turn the air bleed valve (2) to the open position (O). 5. Turn electric priming pump switch (3) to the ON position (A). Lamp (4) flashes and the electric priming pump starts. Release electric priming pump switch (3). Switch (3) will return automatically to the original position (N). REMARK While lamp (4) is flashing, the electric priming pump is actuated for 30 seconds and then stops for 10 seconds. This action is repeated until lamp (4) goes out. 9. Turn air bleed valve (2) to the closed position (S).

4 - 41 I f this switch i s turned to the OFF positi on (B) whe n the la mp is flashing, the l amp will go ou t and t he el ectric prim ing pum p wil stop. p is flashing, the electric priming pump will stop, When the lam the electric priming pu mp will stop, but this does not indicate an y abnormal ity. 6. When the sp ecified time (approx. 7 minutes) has passed, lamp (4) automatically goes out and the electric p stops. priming pump automatically stops working (the monitor lamp goes off), when the fuel circuit is el as in the instance that the engine stops due to fuel exhaustion, or in the instance that the fuel priming pum 7.

The electric priming pump el as in the in working emptied of fu stance that the engine stops due t o fuel exhaustion, or in t he instance that the fuel hose, tube or priming pum p has been maintained or replaced In tilt the electric priming pu mp switch back t ON position (A) so as to 8. When the la mp goes out, t he air bleed operation is completed