Komatsu — CHECK ENGINE VALVE CLEARANCE, ADJUST

. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN FINAL DRIVE CASE WARNING REMARK Check the O-rings in the plugs for damage. If necessary, replace with new ones. 4. Tighten plug (P). 4 - 74 EVERY 2000 HOURS Maintenance for every 10, 100, 250, 500, and 1000 ho urs of service should be performe The parts and oil are at high temperature immediately after the engine is stopped, and may cause serious burns. Wait for the temperature to go down be fore starting the operation. If there is still pressure rem aining inside the case, the oil o r plug may Loosen the plug slowly to r Refill capacity: each 22 l Refill capacity: Left, righ t 21 liters (5.6 US gal) each Prepare a handle.

Set the TOP mark at th perpendicular to the gr Set a container under 3. Remove plugs (P) and (F) with the handle and dra in the oil. 5. Add oil through the hol 6. When the oil overflows from the hole of plug (F), inst all plug (F). Tightening torque of pl ugs (P) and (F) : 12.5 kgm, 68.7 - 90.4 lbft) 93.1 - 122.5 Nm (9.5 - CHECK BOOST PIPING Ask your Komatsu distribut or to carry out the inspectio CHECK ALTERNATOR There is a possibility that t he bearing is short of greas e. Call your Komatsu distributor for inspection and repair CHECK ENGINE VALVE CLEARANCE, ADJUST Special tools are needed f or inspection and maintenan ce, so contact your Komatsu distri