Komatsu — CHANGE OIL IN HYDRAULIC TANK, CLEAN STRAINER

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE valve (P) and plug (1). Tightening torque: 68.6 ± 9.8 Nm (7 ± 1 kgm, 50 ± 7 lbft) When removing drain valve (P), take care not to pour oil over yourself. 4 - 84 5. bottom valve ( of the chassis. Remove pl P) and drain the oil. After dra ug (1), then loosen drain ining the oil, tighten drain 6. Remov e 4 bolts, then remove cover (4). When doing this, cover (4) may fly off because of the force cover p ushed down when removing 7. Hold th strainer 8. Remov e any dirt stuck to strainer (7) , then wash in clean diesel oil or flu shing oil. If strainer (7) is br oken, replace it with a new part. 9.

When i nstalling, insert strainer (7) in to protruding part (8) of the tank, a nd assemble. the specified amount of oi l through oil filler port (F). 10. Fill with Check that the oil level is within the correct range on the sight gauge. 11. Bleed t he air from the circuit after cl eaning or replacing the filter element or strainer, or after changing the oil.