STARTING AND OPERATING STARTING AND OPERATING Normal Weather When the outside temperature is above 50° F (10° C), you can use the following procedure: Some starters are equipped with over- crank protection. Check the “Engine Operation and Maintenance Manual” for details. NOTE Introduction Since each vehicle is custom-equipped, all engine operation instructions in this manual are general. You will want to consult the manual for your engine to find out details about your specific engine’s needs. You may need to use a slightly different procedure from the one outlined here. 1. Set the parking brake. 2. Put your main transmission in Neutral. 5. Turn the ignition key to the START position.
If the engine does not start within 30 seconds, release the ignition switch. To avoid overtaxing the starter motor or the batteries, don’t use the starter for more than 30 seconds. Let the starter motor cool and the batteries recover for two minutes before trying again. If the engine still won’t start after a couple of tries, check the fuel lines for possible fuel starvation or air leaks. Starting failure may mean fuel isn’t reaching the injectors. 3. Disengage (depress) the clutch (with manual transmission). 4. Turn the key switch to ON. 4 Below are instructions for both normal-temperature starting and cold-weather starting.
CAUTION Never operate the starter motor while the engine is running. The starter and flywheel gears could clash or jam, se verely damaging them. 6. As soon as the engine starts, begin to watch the oil pressure gauge. Check your engine manufacturer’s (04/13) Y53-1200-1B1 4-5