PACCAR Inc. T680 — Auxiliary Axles - Pusher or Tag

AXLE General Calibration Guidelines 4. Adjust the amount of load on each axle by turning the pressure regulator clockwise to increase the load or counterclockwise to decrease the load. (The suspension manufacturer may publish pre-established Pressure-to-Load Ratio Pressure Settings to assist you in achieving an estimated ground load). Operation guidelines These instructions are general in nature. For more specific instructions, review the pusher or tag suspension manufacturers maintenance manual or contact the nearest authorized dealer. Steerable-pusher and/or tag axle(s) will raise when the transmission is shifted into reverse or when the park ing brakes are applied.

NOTE NOTE Perform this procedure at or near a weight scale. Procedure can be per formed while parked on the weight scale if scale is available. Maximizing Drive Axle Traction 5. After setting the pressure to obtain the desired axle load, verify proper ground loading with the weight scale. Adjust the pressure regulator control knob to a lower pressure until desired traction is obtained. By reducing air pressure at pusher or tag axle, load will be transferred to drive axles. Do not overload drive axles. 4 1. Park loaded vehicle on level surface with wheels blocked. 2. Release vehicles spring brakes. (Do not release for Liftable/Non-Steerable pusher or tag axles).

NOTE Exceeding local, state or federal weight limits may result in citations. Contact your local commercial weight enforcement office for limits in your area. Coupling to a Loaded Trailer Inflate air springs of the auxiliary axles to the desired pressure after coupling to a loaded trailer while still maintaining proper traction of the drive axles. 3. Lower the pusher/tag axles with the axle lift control flip valve. (For some non-liftable axles, inflate air suspension). Unloading Operation (04/13) Y53-1200-1B1 4-47