PREVENTIVE MAINTENANCE SCHEDULE 5 5-22 Y53-1200-1B1 (04/13) PREVENTIVE MAINTENANCE (PM) INTERVALS SYSTEM COMPONENT MAINTENANCE TASK Recommended PM Interval I A B C D E Hub, Drum, and Hubcap Hubs (non-LMS) Check the bearing endplay and adjust as required (shown on page 5-47). X Hubs (non-LMS) with outrunner seals Clean the components and check for excessive wear or damage. Change the oil and seal (shown on page 5-47). X Hubs (non-LMS) with standard seals Clean the components and check for excessive wear or damage. Change the oil and seal (shown on page 5-47). X Hub seals (all) Check for leaks; replace as required. X LMS Hubs (Dana) Inspect for leaks.
Check the bearing endplay and adjust as required (shown on page 5-47). X LMS Hubs (Dana) with Synthetic Lubricant Service the bearings, seals and oil. This interval may be different depending on the results of the regular inspection. (shown on page 5-47). 500,000 miles/ 800,000 km LMS Hubs (Dana) with Mineral Lubricant Service the bearings, seals and oil. This interval may be different depending on the results of the regular inspection. (shown on page 5-47). 350,000 miles/ 560,000 km Brake drums Inspect for visible cracks, heat checking, galling or scoring of the braking surface, and for severe corrosion on the outside surface. Check for out-of-round or oversize condition [0.080 in.
(2 mm) more than the original diameter]. Replace as required. X Hubcaps Clean the sight window. Check the center plug, mounting flange, and fill plug for leaks and for proper installation. Replace broken or damaged parts. Check the lubricant level and add as required. X