PACCAR Inc. T680 — Universal Joint Lubrication

LUBRICANT SPECIFICATIONS Wheel Bearing Lubrication Oil-lubricated Driven Hubs Oil-lubricated Nondriven Hubs Universal Joint Lubrication Use CD50 synthetic transmission fluid SAE 50W or equivalent. A minimum of 9 oz. (270 ml) of lubricant is required for proper lubrication of an LMS™ hub; 10-13 oz. (295-400 ml) is required for a non-LMS hub, depending on wheel design. Allow time for the fluid to seep through the bearings when initially filling a hub. When properly filled, the fluid level will lie between the fluid level line and 1/4” above the line. Refer to the Spicer Universal Joints and Driveshafts service manual and lubrication specifications.

Use hypoid oil, A.P.I.-GL-5 SAE 75W-90FE synthetic gear lubricant or equivalent. A minimum of 1 quart (921 ml) of oil is required for proper lubrication of each drive hub. Add oil through the filler hole in the hub; if none, add oil through the differential filler hole. (Note: Remember to replace vent plug or threaded filler plug when done.) Allow time for the oil to seep through the bearings when initially filling a hub. Maintain the differential oil level by adding oil until its surface is even with the bottom of the filler hole (see illustration on page 5-38). 5 NOTE Remember to replace vent plug when done. (04/13) Y53-1200-1B1 5-47 Type of Lubricant On-Highway Mi.

(km) Maximum Change Interval On/Off Highway Severe Service Mi. (km) Maximum Change Interval Mineral-Based 120,000 (192,000) Yearly 60,000 (96,000) Yearly Eaton-Approved Synthetic 240,000 (384,000) 2 Years 120,000 (192,000) Yearly Eaton-Approved Synthetic in axle with extended drain interval option 350,000 (560,000)