PACCAR Inc. T680 — Introduction

AIR SYSTEM WARNING! WARNING! reservoirs to be stored until needed. When you operate your air brakes, the stored compressed air flows into the chambers where it is used to apply your truck and trailer brakes. That is why, when you push down on your brake pedal, you don’t feel the same amount of pressure on the pedal that you do when you apply the brakes on your car. All you are doing on your truck is opening an air valve to allow air to flow into the brake chambers. Never attempt to disassemble a com ponent until you have read and un derstood recommended procedures. Some components contain power ful springs and injury can result if not properly disassembled.

Use only proper tools and observe all precau tions pertaining to use of those tools. Failure to comply may result in death, personal injury, equipment or property damage. Completely bypassing a Bendix® AD-IS air dryer will bypass the sys tem’s pressure protection valves. This could lead to loss of air pressure or damage to the vehicle’s air system, which could cause an accident involv ing death or personal injury. Always adhere to the manufacturer’s proce dure if it is necessary in an emergency to temporarily bypass an AD-IS-series air dryer. Failure to comply may result in death, personal injury, equipment or property damage.

Contamination of the air supply system is the major cause of problems in air-operated components such as brake valves, and suspension height control valves. To keep contaminants to the lowest possible level, follow these maintenance procedures. 5 The operation of the vehicle’s braking system and many vehicle accessories depends upon the storage and application of a high-pressure air supply. Your vehicle’s compressor takes outside air and compresses it, usually to 100-120 psi (689-827 kPa). The compressed air then goes to the 5-50 Y53-1200-1B1 (04/13)