PACCAR Inc. T680 — Batteries

ELECTRICAL Follow the procedure below to reinstall batteries on the vehicle: Replacing Parts Removed for Access WARNING! 1. Replace battery cover. Fairings not installed properly could come loose and cause other motorists to have an injury accident. It is impor tant that fairings be installed properly. Failure to comply may result in death, personal injury, equipment or property damage. NOTE 2. Install 2 bolts in step strut. Torque to 24-32 lb-ft (33-43 Nm). Make sure to reconnect the ground (negative) cable last. 3. Install fairing and install 4 bolts. Torque to 6-7 lb-ft (8-9 Nm). 1. Place batteries in vehicle and tighten bolt of holding plate. 4.

Install steps by installing 2 bolts in each step. Torque to 24-32 lb-ft (33-43 Nm). 2. Reconnect positive cable. WARNING! 3. Reconnect ground (negative) ground cable. WARNING! Before attempting any work on the bat teries or electrical system, remove all jewelry. If metal jewelry or other metal comes in contact with electrical cir cuits, a short circuit may occur causing you to be injured, as well as electrical system failure and damage. Always reinstall the steps before en tering the cab. Without the steps you could slip and fall, resulting in possible injury to yourself. 5 Battery replacement may alter or dis turb battery cable routing.

Check to in sure battery cables are free from any point of chaffing. Failure to comply may result in death, personal injury, equipment or property damage. WARNING! 5-88 Y53-1200-1B1 (04/13)