NOISE AND EMISSION CONTROL Air Intake System Engine Mounted Noise Insulators Exhaust System Do all checks and maintenance Check condition. Is the insulator procedures listed in this manual secure? How you do this will under Engine Air Intake System depend on the method of attaching and Air Cleaner. See Air Dryer on the noise insulators on the engine page 5-52. and around the oil pan (bolts, snap fasteners, or straps). Tighten Check the induction tubing, elbow loose fasteners and repair or connections, clamps, brackets, replace any worn or damaged and fasteners for deterioration, fasteners. cracks, and security.
Check for exhaust leaks, which would indicate a leaking manifold gasket; replace gasket if necessary. Check cap screws for tightness, including those at the flanges. Refer to the engine manufacturer's service manual for proper tightening sequence and torque values. Check insulators around fasteners If you find an air leak anywhere and stress points, especially between the air cleaner and where they may be affected by the engine, repair that leak engine vibration. Repair any immediately. cracked or damaged mounting points. Use suitable reinforcing plates to ensure that the insulators Air leaks cause excessive noise and 5 will remain in position. may result in serious damage to the engine.
If you do not repair them the engine damage will not be covered by your warranty. Repair all air leaks as soon as you find them. CAUTION (04/13) Y53-1200-1B1 5-119