PACCAR Inc. T680 — U-Joints

DRIVELINE DRIVELINE U-Joints For SPL170XL and SPL250XL, the U-joint lube interval changes after the initial lube at 350,000 miles. After the first lube interval, the U-joint needs lubrication every 150,000 miles. Inspection of the U-joints is the same regardless of when the U-joint grease interval occurs. Driveshaft Maintenance The slip joints and universal joints of the driveshaft should be lubricated periodically. Use a good quality lithium-soap-base or equivalent extreme pressure (E.P.) grease: NLGI Grade 2. WARNING! Improper lubrication of U-joints can cause them to fail prematurely. The driveshaft could separate from the ve hicle and result in an accident.

Make sure lubricant is purged at all four ends of each U-joint and loosen caps if nec essary. Also, regularly inspect U-joints for excessive wear or movement, and repair or replace as necessary. Fail ure to comply may result in death, personal injury, equipment or property damage. Dana SPL U-joints and driveshafts should be inspected every time a vehicle comes in for scheduled maintenance (Refer to Spicer Driveshaft service manual DSSM-0100 (3264-SPL) for detailed instructions). The slip joints and universal joints of the drive shaft should be lubricated according to Preventive Maintenance Schedule on page 5-12.

5 Use a good quality lithium-soap-base or equivalent extreme pressure (E.P.) grease: NLGI Grade 2. Use only Spicer Driveshaft approved lubricants when greasing Spicer SPL U-joints. Use only Spicer Driveshaft approved lubricants when greasing Spicer SPL U-joints. (04/13) Y53-1200-1B1 5-135