PACCAR Inc. T680 — Fuse or Relay Blows

WHAT TO DO IF... CAUTION Fuse Inspection and Replacement If it is blown, replace it with a fuse of the same rating. Before replacing a fuse, turn OFF all lights and accessories and remove the ignition key to avoid damaging the electrical system. All the electrical circuits have fuses to protect them from a short circuit or overload. If something electrical on your chassis stops working, the first thing you should check for is a blown fuse. If a fuse of the same rating is not available, a fuse of a lower rating may be temporarily substituted. You can also use a fuse from a circuit you can do temporarily without (for example an accessory circuit or radio).

2 CAUTION Never patch fuses with tin foil or wire. This may cause serious damage else where in the electrical circuit, and it may cause a fire. 1. Turn OFF all lights and accessories and remove the ignition key to avoid damaging the electrical system. CAUTION 2. Determine from the chart on the fuse panel which fuse controls that component. When replacing a failed circuit breaker, always use an approved cir cuit breaker with a current rating equal to or less than the circuit breaker be ing replaced. Only use the approved Type II modified reset circuit breakers. NEVER use a Type I (automatic re set) or Type III (manual reset) circuit breaker.

A fuse with a current rating equal to or less than the circuit breaker being replaced can also be used. CAUTION If a circuit keeps blowing fuses, have the electrical system inspected for a short circuit or overload by an autho rized dealer as soon as possible. Fail ure to do so could cause serious dam age to the electrical system and/or ve hicle. 3. Remove that fuse and see if it is blown. 1 Blown (04/13) Y53-1200-1B1 2-7