PACCAR Inc. T680 — Introduction

JUMP STARTING VEHICLES 7. If either vehicle is equipped with Connect the batteries: 6. Start the vehicle that has the battery disconnects ensure they 1. Attach one end of a jumper cable good battery first. Let it run for 5 are in the "OFF" position prior to to the positive (+) terminal of the minutes. connecting the two vehicles. discharged (dead) battery. This 7. Start the vehicle that has the will have a large red + or P on the discharged (dead) battery. battery case, post, or clamp. 2 2. Attach the other end of the same If the engine fails to start, do not cable to the positive (+) terminal continue to crank the starter but of the good (booster) battery.

contact the nearest authorized dealer. 3. Attach the remaining jumper cable FIRST to the negative (-) terminal (black or N) of the good battery. 4. Attach the other end of the negative cable to a bare metal part not bolted to the engine block. NOTE Always connect positive (+) to pos itive (+) and negative (-) to negative (-). 5. If either vehicle is equipped with battery disconnects, ensure that they are in the "ON" position. 2-10 Y53-1200-1B1 (04/13)