VEHICLE RECOVERY AND SPRING BRAKES Recovery Procedure the vehicle’s air system is connected to that of the recovery vehicle. Ensure that any air line that has been removed from a driver-controlled main differential lock is firmly capped to prevent loss of air pressure from the recovery vehicle if it is supplying air pressure. If you don’t desire to use the recovered vehicle’s brakes, ensure that you cage the spring brakes before attempting to move the vehicle, see Driver Controlled Main Differential Lock on page 2-16. 1. Review and understand all the cautions and warnings of this section, see Vehicle Recovery Guidelines on page 2-12. 2 2.
Install the recovery hitches, see Recovery Hitch Installation on page 2-15. 3. Disconnect the drive axle shafts and cover the open hubs. This is necessary because if the transmission is driven by the driveshaft (rear wheels on the ground), no lubricant will reach the gears and bearings, causing damage to the transmission. 1 Recovery Hitch Sockets 4. Install the recovery rigging using a safety chain system, see Recovery Rigging on page 2-19. Before towing a vehicle, test your air brakes to ensure that you have prop erly connected and inspected the re covery vehicle’s brake system.
Failure to do so could lead to a loss of vehicle control which may result in an accident involving death or personal injury. WARNING! 5. Make sure the recovered vehicle's parking brakes are released. 6. If you desire to use the recovered vehicle’s brakes, ensure that (04/13) Y53-1200-1B1 2-13