PACCAR Inc. T680 — Spring Brakes—Manual Release

VEHICLE RECOVERY AND SPRING BRAKES WARNING! 2. Remove the release stud assembly from the side pocket, and remove the release nut and washer from the release stud. 5. Assemble the release stud washer and nut on the release stud. Always secure the vehicle with wheel chocks, chains, or other safe means to prevent rolling before manually releas ing the spring brakes. Releasing the spring brakes on an unsecured vehicle could lead to an accident. The vehicle could roll, which may result in death, personal injury, equipment or property damage. 2 3. Slide out the release stud. 6. With a wrench, turn the release stud assembly nut until the compression spring is 90-95 percent caged.

While doing this, check to make sure the push rod (adapter push rod or service push rod) is retracting. Do not over-torque the release stud assembly. (S-Cam type maximum: 50 lb-ft, Wedge type maximum: 30 lb-ft). The spring brake is now mechanically released. To move a vehicle immobilized by the spring brakes due to loss of air pressure in the brake system, perform the following procedure: 4. Insert the release stud through the opening in the spring chamber where the cap was removed. Insert it into the pressure plate. Turn the release stud 1/4 turn clockwise in the pressure plate.

This secures the cross pin into the cross pin area of the pressure plate and locks it into the manual release position. 1. Remove the cap from the spring chamber. (04/13) Y53-1200-1B1 2-21