Safety - Section 2 OM2026.2 02/03 Page 2-20 Warnings and Cautions A warning instruction is applied below the Parking Brake and the Rear Wheel Brake Lock switches, which are located to the right of the steering column on the instrument panel. Pushing the top of the rocker-style switch turns gles, rubber gloves and rubber apron when handling and servic- ing batteries. This plate is placed on both battery boxes and near the battery dis- connect switches to indicate that the battery system (24VDC) is a NEGATIVE (-) GROUND system. These decals are placed above the battery disconnect switches on the right side of the front bumper to indicate "Off" and "On" positions of the switches.
nction ON, pushing the bottom, turns it OFF. The Parking Brake is spring applied and hydraulically released. It is designed to hold a stationar when the engine is shutdown and keyswitch is turned "Off". The truck must be completely st before applying the parking brake, or damage may occur to parking brake.To apply the parking press the rocker switch toward the "On" symbol. To release the parking brake, press the rocker the "Off"symbol. When the keyswitch is "On" and Parking Brake switch is applied, the Parking Brake i t (A3, Overhead Panel) will be illuminated. The Parking Brake is spring applied and hydraulically released. It is des when the engine is shutdown and keyswitch is turned "Off".
The truck before applying the parking brake, or damage may occur to parking bra press the rocker switch toward the "On" symbol. To release the parking the "Off"symbol. When the keyswitch is "On" and Parking Brake switch is app t (A3, Overhead Panel) will be illuminated. The Parking Brake is s when the engine is sh before applying the par press the rocker switch toward the "Off"symbol. When the k tor light (A3, Overhead Panel) will NOTE: Do not use the parking bra caused by loading or dumping coul The Wheel Brake Loc while dumping. It appli apply this brake to stop With engine shut down, Attached to the exterior of the batt plate. This plate stresses the nee sparks near the battery.
When ano The Parking Brake is s when the engine is sh before applying the par press the rocker switch the "Off"symbol. When the k t (A3, Overhead Panel) will ke at shovel or dump. With keyswitch "on" and d cause the system's motion sensor to RELEASE k switch is for holding the truck while parked at es the rear service brakes only. If the brake tr the truck. Do NOT use this brake as a parking the hydraulic system will eventually bleed down, ery compartment is a danger d to keep from making any ther battery or 24VDC power source is used for auxiliary powe prior to making any connections.
power cables, positively maintain positive (+) posts together and th lead of the auxiliary power cable not connect to the negative po near the battery box. This hook minimizes danger of sparks near th Sulfuric acid is corrosive and toxic.