Case IH AFX8010 — ENGINE COOLANT SYSTEM

POWER PRODUCTION - ENGINE COOLANT SYSTEM Sensing system Coolant level - Replace (B.50.A.95.93 - F.10.A.30) AFX8010 Prior operation: ENGINE COOLANT SYSTEM - Drain fluid (B.50.A - F.35.A.20) NOTE: Complete system does not have to be drained for sensor replacement. Drain only until coolant level is below sensor. 1. Open the access door (1) and shielding to gain access to the tank and sensor. 10034690A5 1 2. Disconnect the electrical connection from the harness to the sensor. With a 24mm wrench remove the sensor (1) from the tank (2) . 10034689A5 2 3. To install new sensor (1) install new O-ring (2) over the threads until it is seated on the recessed groove near the hex end.

Apply Teflon thread sealant to the sensor threads. Thread the sensor into the tank until the O-ring becomes in contact with the threaded bung. Thread in the sensor (approximately one turn) until the arrow on the Hex head is facing up. IMPORTANT: Do not over torque the sensor. The threads are plastic and can easily strip. Apply only enough torque until O-ring is gently seated, and arrow is facing up. ATTENTION: It is important that you verify the arrow on the sensor is facing up for the sensor to operate properly. 50034910A5 3 9675 1 27/05/2004 B.50.A / 36