POWER PRODUCTION - LUBRICATION SYSTEM Sensing system Oil pressure - Short circuit to B+ (B.60.A.95.91 - G.30.B.54) AFX8010 E0161-03 - Oil Pressure Sensor Cause: The engine oil pressure sensor (B-52) circuit is shorted to 12 volts. Possible failure modes: 1. Switch supply wiring shorted to 12 volts . 2. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "ENGINE" sort menu, and select "OIL PRESS SEN" to check the voltage range. The proper voltage range for the engine oil pressure sensor (key On, engine OFF) is - 0.5 - 0.8 volts .
The proper voltage range for the engine oil pressure sensor (key On, engine Running) is - 0.8 - 4.9 volts . A. If the voltage reading is high out of range (> 5.2 volts ), continue with Step 2 . B. If voltage is normal, the shorted wire may not be energized at this time. Continue with Step 9 . NOTE: Visually inspect the wiring harness and connectors. Verify that the connector was fully installed. Inspect the terminals and wires at the connector for pushed back or corroded terminals or damaged wires. Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2. Disconnect the engine oil pressure sensor connector X337 .
Use a multimeter to check for voltage on connector X337 pin B. There should be 5 volts present. A. If high (> 5.5 volts ) voltage is found, the regulated voltage supply is incorrect. The error " E0165-03 - CCM2 J2 5V Reference " should be listed in the Universal Display Plus "ERROR" screen. Correct that error, and then check to determine if this error has been resolved. B. If correct voltage is found, continue with Step 3 . 3. Disconnect the engine oil pressure sensor connector X337 . Use a multimeter to check for continuity between connector X337 pin A and chassis ground. A. If continuity is found, continue with Step 6 . 4.
Disconnect the Iveco engine harness from the engine (EN) harness at connector X197 . Use a multimeter to check for continuity between the engine (EN) harness end of connector X197 pin 4 and chassis ground. B. If no continuity is found, continue with Step 4 . A. If there is no continuity, continue with Step 5 . B. If there is continuity, there is an open circuit in the Iveco engine harness between connector X197 pin 4 and connector X337 pin A on the brown wire. Locate the open and repair. 5. Disconnect the engine harness (EN) from the main frame (MF) harness at connector X010 . Use a multimeter to check for continuity between the harness end of connector X010 pin 14 and chassis ground. A.
If there is continuity, there is an open circuit in the engine (EN) harness between connector X010 pin 14 and connector X197 pin 4 wire 853 blue or 468 blue. Locate the open and repair. B. If there is no continuity, there is an open circuit in the main frame (MF) harness between connector X010 pin 14 and connector X016 pin J2-14 wire 468 blue, 425 blue or 465 blue. Locate the open and repair. 9676 1 27/05/2004 B.60.A / 25