Case IH AFX8010 — STARTING SYSTEM

POWER PRODUCTION - STARTING SYSTEM STARTING SYSTEM - Problem solving (B.80.A - G.40.A.30) AFX8010 OPERATION The starting system consists of two batteries, a Neutral start relay K-23, Start relay K-36, 24V Start relay K-38 and 24V Starter motor M-29. All components must function properly in order for the starting system to operate. For more information on starting system operation, refer to: STARTING SYSTEM - Dynamic description (B.80.A - C.30.A.10) TROUBLESHOOTING Before troubleshooting the starting system, make sure that the following operating conditions are met: 1. The batteries are fully charged and all the connections are clean and tight. 2. Check fuses F-38 and F-48. 3.

Transmission in Neutral or Park. 4. Battery switch closed. NOTE: The batteries must be fully charged and all the connections clean and tight. Use a multi-meter (DVOM) for these tests. For battery testing and service, see the battery section in the service manual. WARNING M980 - Before performing any of the electrical tests, be sure all operating controls are in neutral or park lock position. This will eliminate accidental movement of the machine or start-up of power driven equipment. IMPORTANT: Do not use a self-powered test light for any of the following tests. Use of a self-powered test light may cause damage to components in this system.

9677 1 27/05/2004 B.80.A / 9 Problem Possible Cause Correction Engine does not crank when key is turned to "Start" position.

Fuse F-38 Start control Start switch - Testing (B.80.A.90.82 - G.40.A.20) Key Switch S-02 Start control Start switch - Testing (B.80.A.90.82 - G.40.A.20) Start control Start switch - Testing (B.80.A.90.82 - G.40.A.20)Test Points 1 and 2 Neutral Switch S-22 Start control Safety switch - Testing (B.80.A.90.81 - G.40.A.20) Neutral Start Relay K-23 Start control Neutral start relay - Testing (B.80.A.90.84 - G.40.A.20) Start Relay K-36 Start control Start relay - Testing (B.80.A.90.80 - G.40.A.20) 24V Start Relay K-38 Start control 24V start relay - Testing (B.80.A.90.85 - G.40.A.20) Starter Motor M-29 Engine starter - Testing (B.80.A.82 - G.40.A.20) Click is heard when key is turned, but engine does not crank 24V Starter Motor M-29 Engine starter - Testing (B.80.A.82 - G.40.A.20) 24V Start Relay K-38 Start control 24V start relay - Testing (B.80.A.90.85 - G.40.A.20) Start Relay K-36 Start control Start relay - Testing (B.80.A.90.80 - G.40.A.20) Neutral Start Relay K-23 Start control Neutral start relay - Testing (B.80.A.90.84 - G.40.A.20) Engine cranks slowly 24V Starter Motor M-29 Engine starter - Testing (B.80.A.82 - G.40.A.20)