Case IH AFX8010 — STARTING SYSTEM

POWER PRODUCTION - STARTING SYSTEM Cold start aid Relay - Testing (B.80.A.30.21 - G.40.A.20) AFX8010 Cold start aid Pre-heating - Testing (B.80.A.30.81 - G.40.A.20) AFX8010 9677 1 27/05/2004 B.80.A / 12 N° Test Point Expected Result Other Result (Possible Cause) 1 Key switch S-02 in the ON position. Measure for 12 volts at Grid Heater Relay K-39 connector X211 pin 1. 12 volts If good reading, Go to test 2 If no voltage is found, Go to test 2 2 Key switch S-02 in the ON position. Measure for 12 volts at Engine Control Unit (ECU) connector X193 pin 3 or 4.

12 volts Open circuit in the engine (EN) harness between connector X193 pin 3 & 4 and grid heater relay K-39 connector X211 pin 1 wire 818 white. Locate open and repair. If no voltage is found, the ECU Power supply circuit is not functioning. Refer to the ECU Power Supply circuit testing for more information. 3 Key switch S-02 in the ON position. Measure for 12 volts at Grid Heater Relay terminal B+. 12 volts If good reading, Go to test 4 If no voltage is found, Go to test 3 4 Measure for 12 volts at Alternator G-01 terminal B+. 12 volts If good reading, there is an open circuit in wire 840 red between the alternator G-01 and grid heater relay K-39 pin B+. Locate the open and repair.

If no voltage is found, there is an open circuit in wire 802 red between the 24V Start relay K-38 and the alternator G-01. Locate the open and repair. 5 Key Switch in the OFF position. Measure resistance from Grid Heater Relay K-39 connector X211 pin 2 to ECU connector X193 pin 10. Less than 1 ohms resistance. If good reading, Go to test 5 If there is excessive resistance, there is an open circuit in the engine harness between Grid Heater Relay K-39 connector X211 pin 2 and ECU connector X193 pin 10 wire 882 black. Locate the open and repair. 6 Remove wire 841 white from the grid heater relay. Connect a jumper wire between the grid heater connector X211 pin 2 and chassis ground.

Key Switch in ON position. Measure for 12 volts at Grid Heater Relay output terminal (white wire connection). 12 volts If good reading, the Grid Heater Relay K-39 is operating properly. Grid Heater Relay K-39 is faulty. Replace relay. N° Test Point Expected Result Other Result (Possible Cause) 1 Engine Grid Heater R-09; use a multimeter to check for resistance between the two terminals. Ohms resistance between two terminals should be approximately 55 ohms. Go to test 2 If resistance is infinite, grid heater is defective and requires replacement. 2 Use a multimeter to check for continuity between the terminal end of the black wire and chassis ground. There should be continuity.

Go to test 3 If resistance is infinite, there is an open circuit between the grid heater and chassis ground. Locate the open and repair. 3 Use a multimeter to check for continuity between the grid heater relay K-39 white wire and the white wire connection to the grid heater. There should be continuity. If resistance is infinite, there is an open circuit in the white wire between the grid heater relay K-39 and the grid heater R-09. Locate the open and repair.