DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM Sensing system Reservoir level sensor - Short circuit to B+ (A.10.A.95.93 - G.30.B.54) AFX8010 E0133-03 - Hydraulic Reservoir Level Sensor Cause: The hydraulic reservoir level switch (S-33) circuit is shorted to 12 volts. Possible failure modes: 1. Switch supply wiring shorted to 12 volts . 2. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "HYDRAULIC" sort menu, and select "RES LEVEL SW" to check the voltage range. The proper voltage range for the hydraulic reservoir level switch is - 1.8 volts or less, oil level okay.
The proper voltage for the hydraulic reservoir level switch when oil level is low is approximately 8.3 volts . A. If the voltage reading is high out of range (> 10 volts ), continue with Step 2 . B. If the voltage reading is within the proper limits, the shorted wire may not be powered up at this time. Continue the troubleshooting at Step 4 . NOTE: Visually inspect the wiring harness and connectors. Verify that the connector was fully installed. Inspect the terminals and wires at the connector for pushed back or corroded terminals or damaged wires. Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2.
Disconnect the hydraulic reservoir level switch connector X104 at the reservoir. A. If the voltage drops back into the proper range the short is in the switch, or switch wiring. Replace the switch. B. If the voltage remains high, continue with Step 3 . 3. Disconnect the gearbox harness from the main frame harness at connector X011 . A. If the voltage drops back into the proper range, the short is in the gearbox (GB) harness between connector X011 pin 3 and connector X104 pin B wire 424 yellow. Locate and repair. B. If the voltage remains high, the short circuit is in the main frame (MF) harness between connector X011 pin 3 and connector X016 pin J2-39 wire 424 yellow. Locate and repair. 4.
Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or broken wires. A. If no damage is found, erase the fault code and continue operation. 9665 1 27/05/2004 A.10.A / 10 1