POWER TRAIN - POWER COUPLING Fixed coupling 9. Subassemble Engine Input shaft. Place gear (2) on shaft (1) and retain with 2 retaining rings (3) . Short side of gear goes to short end of shaft and the narrow side of snap ring away from gear. Press cones (4) onto shaft (1) using appropriate drivers for each cone. Check to see each cone is fully seated. 10035834A5 9 10. Subassemble Separator Clutch and Unload Clutch shafts. Press spring pins (2) into holes in shaft (1) . 50040355A5 10 11. Ends of pins must be 0.8 - 1.8 mm ( 0.031 - 0.071 in ) below OD. 10035838 11 12.
Coat tapered end of dowel pins (2) with a small amount of Loctite 609 and install into holes in first step flange above drum using a driver to the depth shown. 50040357A5 12 9679 1 27/05/2004 C.10.B / 13