Case IH AFX8010 — POWER COUPLING Fixed coupling

POWER TRAIN - POWER COUPLING Fixed coupling 24. Unload Clutch Cover Assembly. Place bearing cup (3) onto upper shaft. Measure height of cup above cover (1) mounting surface. Measure depth of cup seating surface relative to cover mounting flange. Calculate required thickness of shims (2) to give a rolling torque of 0.2 - 1.2 Nm ( 2 - 11 lb in ). Press required shims (2) and bearing cup (3) into cover (1) using driver. Check to be sure cup is fully seated. 10035853A5 24 25. Rotor CVT and CVT Drive Motor (Variator) Assembly. Remove and set aside the O-ring type seal from end of variator assembly (2) to prevent damage.

Using a 12 mm wrench remove the two small bolts (1) retaining the bearing flange (2) to assembly and set them aside. Carefully separate bearing flange (2) from rest of variator assembly. Clean the mating surfaces of the flange and the variator assembly. NOTE: Use caution there are 8 springs (3) trapped in the assembly by this part and they must be retained. 10035862A5 25 26. Place the cup (3) part of the bearing onto rotor drive gear assembly. Measure the height of cup above variator mounting surface (1) . Measure the depth of cup seating surface relative to variator mounting flange.

Calculate required thickness of shims (2) to give the desired rolling torque of 0.2 - 1.5 Nm ( 2 - 13 lb in ). Press required shims (2) and bearing cup (3) into variator mounting flange (1) using a driver. Check to be sure cup is fully seated. 27. Place O-ring (1) in groove on inner face of the Unload Clutch mounting flange (2) and dab with Petroleum jelly to hold in place. 10035856A5 26 20035857A5 27 9679 1 27/05/2004 C.10.B / 17