Case IH AFX8010 — POWER COUPLING Fixed coupling

POWER TRAIN - POWER COUPLING Fixed coupling 34. Temporarily bolt variator mounting flange over variator gear hub using 10 washers and bolts. Torque bolts to 89 - 100 Nm ( 66 - 74 lb ft ) using an 18 mm torque wrench. Orient mounting flange as shown. 20035860 30 35. Rotate shaft using torque tool with gauge, and note the rolling torque value. Rolling torque should be 0.2 - 1.5 Nm ( 2 - 13 lb in ). Remove mounting flange (1) and set bolts aside. 20035861A5 31 36. Assemble Input Cover. Place O-ring in groove on inner face of appropriate input cover and dab with Petroleum jelly to hold in place. Note the oil port location. 37. Bolt input cover over Engine Input shaft using 8 washers and 8 bolts.

Make sure oil port is oriented to the top. Torque bolts to 89 - 100 Nm ( 66 - 74 lb ft ) using an 18 mm torque wrench. Thread an M12 bolt into the end of the shaft. Check rolling torque using a tool with an 18mm socket. Torque should be 0.2 - 1.2 Nm ( 2 - 11 lb in ). Remove M12 bolt from end of shaft and set aside. Drive shaft seal into cover using a driver and be sure it is fully seated. 38. Rotor CVT and CVT Drive Motor Shaft seal. Remove rotor variator sleeve (1) that was temporarily installed. Place O-ring in groove on pilot of rotor variator sleeve assembly and dab with petroleum jelly to hold in place. Place the seal over the expander tool and slide tool over shaft C6.

Start with the last groove and work your way back towards the end of the shaft. Using a tool resize all three seals. Liberally brush seals with petroleum jelly. 10035855A5 32 9679 1 27/05/2004 C.10.B / 19