POWER TRAIN - TRANSMISSION Mechanical black, connector X017 pin J3-10 to front frame (FF) harness splice, or wire 538 black, harness splice to front frame ground #2.Locate the open and repair. After repair, go to step 17 . B. If there is continuity to ground, continue with step 17 . 17. Once it has been verified that power is being supplied to the module, recheck circuit operation as described in step 1. A. If the fuse fails during testing, a short to ground on the circuit to the transmission shift motor is causing the fuse to fail. Start the troubleshooting at step 3 to locate the short to ground. B. If the circuit operates properly, erase the fault codes and continue operation.
Electrical motor - Overview (C.20.B.82 - C.10.A.10) 10004664B4 1 The transmission shift motor M-02 (1) is located on the top left rear corner of the transmission. The motor is mounted to a right angle drive gearbox, and drives a gear inside the transmission to rotate the shifting disc that controls the movement of the shift forks. The transmission shift motor M-02 is connected ( X094 ) to the lower frame (LF) harness at (2) , and is controlled by the CCM2 module through connector X017 as follows:
The CCM2 module uses two pairs of pins to send current to the transmission shift motor using an H-bridge controlled circuit, which reverses the power and ground connections to the transmission shift motor in order to move it in either direction. The CCM2 module monitors both sides of the circuit during operation; in the event that a fault occurs with the motor or wiring, a fault code will be displayed to the operator. E0171-06 - Transmission Shift Current Sense E0203-11 - Transmission Shift Motor For additional information on the gear shifting process, refer to: Electrical motor - Dynamic description (C.20.B.82 - C.30.A.10) .
9680 1 27/05/2004 C.20.B / 81 Transmission shift motor function Pin number at CCM1 connector X017 Up-shifting J3-19, J3-20 = power; J3-39, J3-40 = ground Down-shifting J3-39, J3-40 = power; J3-19, J3-20 = ground