POWER TRAIN - TRANSMISSION Mechanical B. If there is no continuity to ground, there is an open circuit in the front frame (FF) harness between connector X023 pin 5 and connector X017 pin J3-18 wire 042 blue or wire 766 blue. Locate the open and repair. 6. Operate the transmission shift gear switch to change the transmission gears, and monitor the "POS 1 SEN" voltage readings on the Universal Display Plus. A. If a high ( 7.3 - 9.0 volts ) voltage reading is now viewed, continue the troubleshooting at step 2 . B. If a high ( 7.3 - 9.0 volts ) voltage reading cannot be generated, clear the fault code and continue operation.
Sensing system Shift position sensor - Overview (C.20.B.95.81 - C.10.A.10) 10004664A5 1 The transmission shift position sensor B-37 (1) is located on the top rear of the transmission housing, directly above the shifting disc. The transmission shift position sensor contains 5 position sensors internally, arranged in a horseshoe pattern, which are used to determine the position of the shifting disc. The shifting disc has a pin that is positioned to travel under the transmission shift position sensor as the shifting disc is rotated to select a gear in the transmission.
The transmission shift position sensor is connected ( X093 ) to the lower frame (LF) harness at (2) , and provides an input to the CCM2 module at connector X017 as follows: When a gear can not be engaged because of either mechanical reason or failure of one of the internal sensors in the transmission shift position sensor B-37, the software in CCM2 will allow another gear to be selected. NOTE: Refer to the Operator’s manual for information on the manual gear shifting procedure.
The transmission shift position sensor B-37 circuit is also monitored by the CCM2 module; in the event that a fault occurs with one of the internal sensors or the wiring to the sensor, a fault code will be displayed to the operator.
E0128-03 - Trans Shift Position N Sensor E0128-04 - Trans Shift Position N Sensor E0128-05 - Trans Shift Position N Sensor E0129-03 - Trans Shift Position 3 Sensor E0129-04 - Trans Shift Position 3 Sensor E0129-05 - Trans Shift Position 3 Sensor E0130-03 - Trans Shift Position 2 Sensor E0130-04 - Trans Shift Position 2 Sensor E0130-05 - Trans Shift Position 2 Sensor E0131-03 - Trans Shift Position 1 Sensor E0131-04 - Trans Shift Position 1 Sensor E0131-05 - Trans Shift Position 1 Sensor E0132-03 - Trans Shift Position 4 Sensor 9680 1 27/05/2004 C.20.B / 143 Gear Pin Number 1 J3-36 2 J3-37 N J3-28 3 J3-38 4 J3-27