POWER TRAIN - TRANSMISSION Hydrostatic Motor - Check (C.20.F.28 - F.40.A.11) AFX8010 1. Major repairs are those which require the removal of the end cap or side cover. Repairs of this type are to be performed by Sauer-Sundstrand Authorized Service Centers and or original equipment manufacturers who have the personnel adequately trained to perform such repairs. Performing major repairs on the Sauer Series 90 Hydrostatic Transmission may affect the unit warranty status. Contact a branch manager of Sauer Sundstrand before attempting to service a Series 90 motor. 2. Cleanliness is a primary means of assuring satisfactory hydraulic life on either new or repaired units.
Cleaning parts by using clean solvent wash and air drying is usually adequate. As with any precision equipment, all parts must be kept free of foreign materials and chemicals. Protect all exposed sealing surfaces and open cavities from damage and foreign material. 3. During the assembly of the Sauer Series 90 variable motor, all surfaces, which have relative motion between two parts, should be coated with a film of clean hydraulic oil. this will assure that these surfaces will be lubricated during start-up. 4. Replace all O-rings and gaskets. Lightly lubricate all O-rings with clean petroleum jelly prior to assembly.
All gasket sealing surfaces must be cleaned prior to installing new gaskets. 9681 1 27/05/2004 C.20.F / 23