POWER TRAIN - TRANSMISSION Hydrostatic The hydrostatic motor temperature sensor B-46 (1) is located at the case drain tee at the top of the hydrostatic motor, and monitors the temperature of the case drain oil exiting the motor. The sensor is connected ( X091 ) to the lower frame (LF) harness, and provides an input to the CCM1 module at connector X020 pin J3-33. The hydrostatic motor temperature sensor B-46 circuit is also monitored by the CCM1 module; in the event that a fault occurs with the sensor itself or the wiring to the sensor, a fault code will be displayed to the operator.
E0023-03 - Hydrostat Motor Temperature Sensor E0023-04 - Hydrostat Motor Temperature Sensor E0023-05 - Hydrostat Motor Temperature Sensor The input from the hydrostatic motor temperature sensor B-46 is used to support the Temperature Control System (TCS). CCM1 monitors the temperature of the case drain oil at 10 second intervals; if the temperature of the case drain oil exceeds 105 °C , the hydrostatic pump will be de-stroked at increments of 5 - 10 % , depending on the level of cooling required, until the oil temperature is reduced to 100 °C for at least 10 seconds. 9681 1 27/05/2004 C.20.F / 37